Jeff_Argon18 wrote:
PINGBEN wrote:
undies wrote:
the problem isn't with the stem (other than the recall on the spacer!!), but with the extension fitting, (with the 2 vertical bolts per side). With any riser spacers it is impossible to stop the extension fitting rotating left/right, so bar ends move together and apart!I agree the design with 2 vertical bolts (aligned with the extension fitting) is too weak. A design with 3 bolts in triangle would have been safer ( but then there would have been very little side adjustements possibilities).
I am not confortable with the aerobars even without riser spacer.
Today, ESM ( the Importer for Argon in France) had accepted that there is a problem. They mentionned that they ( Argon18) are working to design a new piece that would improve the system. A part will improve the system.
They also mentionned that we perceive a high flex in the aerobar when we are static and that it is not that bad when we are on the bike.
[ I will reply to them - in curve , it is unconfortable!!]
Re: East-West movement of extension bars some of you may be experiencing at raised position:
We are in the midst of producing a computer mount that will be shipped to all our distributors/dealers world-wide in the coming weeks. This will not only be a good accessory for your computer set-up but also serve as a bridge between the bars as it is designed by Argon 18 specifically for our configuration.
We do want to maintain as much adjustability as possible and this is a common issue with spacers installed however it is much more noticeable when the bike is stationary without a rider in motion. It takes very little force to turn the wheel in motion. That said we are providing a solution for this, it is coming soon, we will advise our retailers as to shipping timing in the coming weeks. It should be available at your LBS in May however we are working to get it done sooner.
Is the Computer Mount available now?