Login required to started new threads

Login required to post replies

tririg tilt hardware
Quote | Reply
has anybody tried to use it to replace the riser/stack hardware on a felt IA?
Quote Reply
Re: tririg tilt hardware [jwrdds] [ In reply to ]
Quote | Reply
Bump...I'm also curious about this
Quote Reply
Re: tririg tilt hardware [jwrdds] [ In reply to ]
Quote | Reply
I believe the bolt holes are 15mm apart for Felt.

Why not use washers instead?

Eric Reid
AeroFit | Instagram Portfolio
Chapel Hill, NC
Aerodynamic Optimized Bike Fitting, Retul Pre-Purchase Bike Fitting, USAT Level 1 Triathlon Coaching, Nutrition
Ask me: Scody Optimized Speed Suits | CeramicSpeed Oversized Pulley Systems | HUUB Skinsuits and Wetsuits | Ventum Bicycles and Frames
Quote Reply
Re: tririg tilt hardware [ericMPro] [ In reply to ]
Quote | Reply
where do you put the washers? and do you use the same screw lengths or one longer than the other?
Quote Reply
Re: tririg tilt hardware [jwrdds] [ In reply to ]
Quote | Reply
Eric is right...bolt holes don’t line up. I emailed nick about this a while back and he said it wouldn’t work. He has been very upfront about what tr products will and work for my ia I the past and when he said it wouldn’t mix I took him at his word. I can’t believe felt hasn’t created any tilt options as an add on for the ia.
Last edited by: anthonypat: May 15, 19 16:23
Quote Reply
Re: tririg tilt hardware [anthonypat] [ In reply to ]
Quote | Reply
anthonypat wrote:
Eric is ringer...bolt holes don’t line up. I emailed nick about this a while back and he said it wouldn’t work. He has been very upfront about what tr products will and work for my ia I the past and when he said it wouldn’t mix I took him at his word. I can’t believe felt hasn’t created any tilt options as an add on for the ia.

Dcohen or similar sells the stuff on shapeways. Also a member of this forum.
Quote Reply