realbdeal wrote:
Just an FYI, the full version is actually available without entering an email now: https://silca.cc/pages/sppc-form Not sure why that specific link is hard to find but I was getting a bit tired of receiving the same thank you email after putting in my info every time haha.
Thanks that works.
I put in my data:
214 lbs system weight;
worn pavement/some cracks
700c/29"
cat1/cat2/cat3 racing
50/50 weight balance
At the moment I have a 23mm in front and a 25mm on the rear. They measure 24 resp. 26.
For 24mm the calculator gives 102,5 psi;
for 26mm 90,5 psi.
I pump at the moment 100psi in both.
So acc. to Silca that's ok whereby I could lower the 25mm a bit.
Last edited by:
longtrousers: Jul 21, 20 10:53