Recieved my P2M with a Rotor 3d+ crank last week. I just installed the crank on my bike (BSA 68mm) with a BSA30 bottom bracket. However, there is just too much lateral play to fix it with the preload bolt. The manual says I don't need spacers but how else can I fix this problem..?
Result after pushing the non drive side in the frame, it seems like the spindle is a bit too long??
Result after fixing the crank at 40nM
Result after pushing the non drive side in the frame, it seems like the spindle is a bit too long??
Result after fixing the crank at 40nM