This is a ridiculously small torx(?) head I think. Any idea what size is needed to remove them? I need to charge my di2!!!!!
Triathlon Forum
Login required to started new threads
Login required to post replies
Re: Felt IA batpac fastener size??? [MadisonMark]
[ In reply to ]
I would get my set of torx drivers and see which one fit.
Re: Felt IA batpac fastener size??? [jimatbeyond]
[ In reply to ]
Well, my set only goes down to a T-10 and that's still too large.
I was hoping someone would know so that when I go to buy one tomorrow I don't have to buy a whole set of them to try to find the one that I actually need.
I was hoping someone would know so that when I go to buy one tomorrow I don't have to buy a whole set of them to try to find the one that I actually need.
Re: Felt IA batpac fastener size??? [MadisonMark]
[ In reply to ]
MadisonMark wrote:
Well, my set only goes down to a T-10 and that's still too large. I was hoping someone would know so that when I go to buy one tomorrow I don't have to buy a whole set of them to try to find the one that I actually need.
Just go to your local hardware store and spend $10 on a multi-set torx tool that has small sizes. Then you'll be covered for life. :)
That said, I -think- all the small torx screws used on the IA are either t8 or t9, I've seen both sizes referenced for the IA.
I'd guess a T-8. I am making that guess based on the fact on my Felt IA (2018) I had to buy a new Torx wrench to get the nose cone and brake covers off - both a T-8. The smallest I had previously was a T-10 as well. $4-5 on amazon for a single or can get an entire bit set for under $10.
"It's good enough for who it's for" - Grandpa Wayne
"It's good enough for who it's for" - Grandpa Wayne