All, I've been designing a rear storage solution for my P5, since I use the down tube for an aero water bottle.
I've been tweaking it so that it works correctly. It attaches to the seat post and sits right behind the frame above the rear wheel.
Taking it out for a test run tomorrow to see how well it holds up. If it works, I'll get it 3d printed at shapeways. My bike is a 54.
Video of the 3d printed prototype installed on my bike. The printer's output is a bit crude but it does the job.
Video of spinning around the 3d model in Autodesk Fusion 360.
http://www.custombikexcessories.com
Instagram
Facebook
I've been tweaking it so that it works correctly. It attaches to the seat post and sits right behind the frame above the rear wheel.
Taking it out for a test run tomorrow to see how well it holds up. If it works, I'll get it 3d printed at shapeways. My bike is a 54.
Video of the 3d printed prototype installed on my bike. The printer's output is a bit crude but it does the job.
Video of spinning around the 3d model in Autodesk Fusion 360.
http://www.custombikexcessories.com