Re: The ultimate DIY disc wheel cover how-to thread. [JTK28]

shoki

Jan 26, 14 3:57

Views: 30734

Here's what I did:

The material is called curv, I dicided to go with .6mm sheet.
Both covers weight 358 grams.
This non drive side will be attached with 3m 33+ from the inside and all the way around.
The drive side below will be attached as above but with Velcro which is attached to the spokes instead of the tape.



I wasn't sure about saving weight and just goin til the rim starts but think the tape last longer on the flat part of the rim.
Didn't drive it cause of the temp we got but can't wait to get the thing running. It will be attached to an 404 zipp zedtech set which used to run for Saxo bank.

---

-shoki

Last edited by: shoki: Jan 26, 14 4:02

Edit Log:

• Post edited by shoki (Dawson Saddle) on Jan 26, 14 3:59
• Post edited by shoki (Dawson Saddle) on Jan 26, 14 4:00
• Post edited by shoki (Dawson Saddle) on Jan 26, 14 4:02