Hi,
I (more likely: somebody else in the transition zone) broke off the tip of a wing in my down-tube that extends towards the fork on my Transition.
It is not structural, so all I'm looking for is aesthetics and potentially avoiding some sort of moisture ingress into the carbon layer (if that is a thing)
What is the best way to re-seal this?
Is there some specific glue/resin that hardens well? Could I potentially even build up to the original shape with a couple of layers and some sanding back down?
PS: I know, I know: the rubber thingy on the fork is missing which was the cause of all of this. Also: I think the dent on the fork is just cosmetic as well, so not to worried about that,
regards,
Flo
if you can read this
YOU'RE DRAFTING!
I (more likely: somebody else in the transition zone) broke off the tip of a wing in my down-tube that extends towards the fork on my Transition.
It is not structural, so all I'm looking for is aesthetics and potentially avoiding some sort of moisture ingress into the carbon layer (if that is a thing)
What is the best way to re-seal this?
Is there some specific glue/resin that hardens well? Could I potentially even build up to the original shape with a couple of layers and some sanding back down?
PS: I know, I know: the rubber thingy on the fork is missing which was the cause of all of this. Also: I think the dent on the fork is just cosmetic as well, so not to worried about that,
regards,
Flo
if you can read this
YOU'RE DRAFTING!