Also looks like you have to re-cable your bike to install it?
That's 5W at 30mph.....so 1.5W at 20mph (a more typical IM speed).
Looks like you could cut a slot to avoid recabling (then just tape over the slot).
Given that it's non-structural, could have just molded it with cheap plastic or 3D printed.
Personally I'd love to see someone put a 3D print file out there that anyone could use.
The Shiv has a similar plastic "box" that comes in several sizes with the frame so you can adjust depending on your spacer stack.
Powered by: Hat Tip - the power of thanks