Enduro BB86 to BB30 Press-fit BB on a Plasma. anyone done it?

Triathlon Forum
1

I saw that Enduro has a press-fit bottom bracket to allow a BB86 bike to accept a BB30 Quarq or Rotor 3D+. anyone done this? I am doing a similar application with the Rotor BSA30 on my Felt B16 and it works great but am looking at getting a Plasma now

2

Works like a charm. The only issue is if you have a plasma TT that runs Di2 internally. Because there isn’t something covering the crank axle like there is when you install a regular GXP or Shimano pressfit BB, you want to be sure the wires are completely out of the way.

3

Going to run mechanical so no worries there. Thanks much!!

4

quick question, did you run a wave washer on the non-drive side and a few thin plastic shims?

5

I have a Rotor 3D+ SRM and didn’t. But maybe the Sram needs one, I don’t know.