WTB - 80 or 90 mm stem

Classifieds
1

Low rise, something like a +/- 6degree.

80 or 90mm. 26.0 is easier, but i have shims for 31.8 as well, so whatever.

the 3Ts will match, but I’m not looking to be real picky.

Thanks.

2

I have a Syntace F99 90mm stem that is a 26.0. Bought it in anticipation of a new Cervelo build but purchased a Felt with a Bayonet. $40 shipped

http://www.syntace.com/index.cfm?pid=3&pk=379

3

Exactly what I was looking for… if the OP doesn’t want it, I’ll take it…

4

make your own post then
.

5

I want to be fair so I’ll give the OP until noon and then it’s yours.

6

You still have first dibs, no worries.

It just so happens that I was specifically looking for an F99 90mm stem (to match my syntace handlebars and aerobars; currently use a 105mm that is a tad too long), didn’t think I’d have any success with a WTB for something that specific.

7

all yours then. i already pm’d the responder & told him thanks but to sell it to you.

for anybody else who is following this great back & forth, I’m still looking.

8

I have a Ritchey Pro 90mm, the rise is listed on the inside of the stemface as 84deg, but it is pretty low rise by my experience…

9

just checked the parts bin. i have

  1. 26.0 80mm generic 4 bolt faceplate stem. new bike take off, basically new. looks like +/- 6 degrees
  2. 26.0 ritchey PRO? 80mm 2 bolt faceplate stem. used with an IMFL bike check sticker on it (good karma). looks like +/- 6 degrees
  3. 26.0 ritchey WCS, 90 mm 4 bolt faceplate stem. used with a bike check sticker on it. +/- 6 degrees.

in the interest of complete transparency, the ritchey stems have “25.8/26.0” etched on the inside clamp part. i assume that means you can use them for either a 25.8 or a 26.0 bar (i used them on a 26.0 profile basebar). if any of the above might work you can e-mail or PM me.