For some stupid reason the rollout on the computrainer with the cervelo causes it to roll down slower then it should making courses impossible.
Does this happen if the back triangle is too tight? I am thinking that with it tight it causes the roll out to take to long acting like it is tighter then it should be.
I losened it up a bit not sure how much that will help though. I’ve actually had this problem with both p3c i’ve had, but not the T-12.
I dunno…the speed never seems too accurate for me, so I never even pay attention to it. 250watts to go 15mph is definitely odd though. You should only tighten the roller enough so that your tire isn’t slipping.
yeah its accurate to what its actually spinning but not what you would actually be going. Im wondering if its teh actual skewer being overtightened that is causing it.
I use my P2C on the CT. When I calibrate it I shoot for a setting between 2.2 and 2.6. The speed and watts used while on the trainer are pretty much right on when compared to riding outdoors. The only thing, which I am sure happens to everyone, is that the hills on the CT are much tougher than in real life. On a side note I did email Cervelo asking about any dangers of riding a P2C on a trainer and they simply said it was made to handle much more stress than what any trainer could produce.