Official power2max support thread

Place an order, not here yet and I have a couple questions. I was going to pay somebody to do it, but I have all the tools and am pretty mechanically inclined. My only problem is all the different BB30 formats.

I ride a Shiv with an OSBB integrated bottom bracket. The instructions for the Rotor 3d+ say the following:

ONLY NEEDED WITH BB30 FRAMES (BEARINGS ARE
PRESSED DIRECTLY INTO THE FRAME).
IN PRESS FIT 30 FRAMES THE CUPS REPLACE BOTH THE
BEARING AND SEAL.

I hate instructions like this, since it assume a lot of knowledge the average person doesn’t know. From what I have read, but not in these exact words, the OSBB are press fit cups. So

DO I NEED TO USE THE BEARING AND SEAL THAT COME WITH THE CRANK?