How do I remove those pegs from the chainring? I’m using it on a single speed so I don’t need to pair it with another chainring, can they be removed?
Thanks, Dave in VA
How do I remove those pegs from the chainring? I’m using it on a single speed so I don’t need to pair it with another chainring, can they be removed?
Thanks, Dave in VA
How are you going to keep the chain tight when the cranks rotate through the minor axis of the ellipse?
it just does.

This will do it IF the frame has a Der Hanger.
the ring does not require a tensioner.
AND it isn’t a fixed gear, AND it offers enough slack to keep the chain tight through the difference in run out between the major axis, otherwise, he’ll need a complete rear derailleur.
I’m baffled.
-SD
I was wondering that. I would assume that the chain gets a bit tighter and looser…right?
nope. it holds tension the same.
sperdave. i assume since the ring is symmetrical, whatever it looses on the little part it gains back on the big part.
mine is on a SS mtn bike, no tensioner, and it holds tension perfectly thru the rotation of the crank. one of those mysteries of the universe i guess.
the chain wraps the same number of teeth regardless of orientation of the lobes…ie the gear inches never change.
If the pitch of the teeth were to change then you’d have a real problem.
If the gear inches never changes then how does it work?
jaretj
but the chain doesn’t wrap completely around the chainring, only about 3/5s of it, as it rotates off the “tall” side of the ring, where does extra chain go? I’m baffled, but if you’ve got one and it works, I don’t need a further argument, I’ll use your experience and go back to my scribbles and notes.
-SD
The circumfrence changes, the pitch does not. If you divide the chainring into two halves, split accorss the longest axis and split accross the shortest axis those halves would require different amounts of chain, no? Isn’t the increase and decrease in leverage a result of using more, or less gear inches through one rotation?
gtingley: help!
-SD
OK guys, now I’m confused. The chainring that I’m replacing does not have the small round pegs and I’m not really sure what purpose they play? Again, they are going on a SS crankset on my Bianchi Pista. Can I saw them off?
Dave in VA
Those pins aid in shifting from one ring to another. If you’re running the ring on a singlespeed, then you will not make use of the pins since the chain will stay put. They will not hamper the performance of your singlespeed. There’s no need to remove them. You can if you want, but why risk ruining your new ring?
Pins and ramps for shifting are different than the chain drop prevention pins. The chain drop prevention pins are on the outer chainring, and act to assist the rider to recover the chain if it falls off the crankset.
These chain drop prevention pins can be pulled out using vice grips. I generally remove the opposing pin from my bikes (the pin not under the crankarm when in OCP #3 for road, OCP #4 for TT) so that the only pin remaining is the one under the crankarm. I do not recommend removing the shifting ramps/pins.
We offer three Q-Rings that work great on singlespeed MTBs without the need for a chain tensioning device, or derailleur.
104BCD MTB middle 34T for XT and XTR 2007 104BCD MTB middle 38T Downhill/Single-Speed 102BCD MTB middle 33T for-XTR 2003
(I am testing a 52T on the track next spring)

Are the agilis cranks available yet? How much?
Three weeks out: $300 w/o Q-Rings, $500 with
Standard/ceramic bearings in the SABB bottom bracket ($116/$301)


.
do you know if these cranks will work with ergomo?
They take a outboard bearing bottom bracket, such as the SABB or Dura Ace
.