Login required to started new threads
Login required to post replies
ITM says their stem clamps (and consequently their handlebar diameters) are 25.4mm. A lot of other people (or actually most people) like Deda, Cinelli, Ritchey, Profile, etc. make their diameters 26.0mm. 3TTT actually does a 25.8. My question is does it really make a difference? Can I use an ITM stem w/ a Deda bar or vice-versa? If I can't and I decide to get an ITM bar, does it mean that I can't use my profile clip-ons anymore?
Kim
I haven't had problems with ITM stems and Syntace bars. .6 mm is a really small amount.
Im using a ITM stem with a 3T bar, no problems.
I have wanted to respond to this but would hate to give bad advise,i think it would be fine, the difference between the smallest to the largest is only .023 thats twenty three thousands,thats a lot in my line of work but when your talking about a two bolt clamp it will take up that amount and should be fine.