HI All,
Have a bit of an issue. I bought a Planet x exocet 2 Frame only a few months back. I sourced the correct seat post and this week finally sourced a fork (I thought) It was listed as 1/1/8 to 1.5" tapered. But its not, its 1/18 to 33.3mm as i measured it? It looks like the right forks and the shut lines all match up so. Also the headset fits perfectly and its 1/18 to 1.5 as well.
So is there a way to make it fit? I suppose i could get a crown race machined to get it to fit but if there's an off the shelf option that would be better. I cant see though what fork it is though. Its 100% a planet x fork, never used. But searching for planet x forks with those steerer dimensions i cant find one so i'm very confused as to where it came from?
Thanks in advance,
Rob
Have a bit of an issue. I bought a Planet x exocet 2 Frame only a few months back. I sourced the correct seat post and this week finally sourced a fork (I thought) It was listed as 1/1/8 to 1.5" tapered. But its not, its 1/18 to 33.3mm as i measured it? It looks like the right forks and the shut lines all match up so. Also the headset fits perfectly and its 1/18 to 1.5 as well.
So is there a way to make it fit? I suppose i could get a crown race machined to get it to fit but if there's an off the shelf option that would be better. I cant see though what fork it is though. Its 100% a planet x fork, never used. But searching for planet x forks with those steerer dimensions i cant find one so i'm very confused as to where it came from?
Thanks in advance,
Rob