I am about to do the top tube mod on my P2 to run the cables behind the steerer in stead of down the side. I purchased the Jagwire Cable stops to insert after drilling. I have jarwire cables.
My question is this, the 4mm ferrule that slides on the end of the shifter housing is the same O.D. as the 5mm so it will not slide into the cable stop. anyone who has done this how did you go about it? I see Cody Beals ground down the ferrule to make it fit. Was looking for an easier solution than this.
My question is this, the 4mm ferrule that slides on the end of the shifter housing is the same O.D. as the 5mm so it will not slide into the cable stop. anyone who has done this how did you go about it? I see Cody Beals ground down the ferrule to make it fit. Was looking for an easier solution than this.