I installed the aeria hydration system on the QR PRSix 2 and noticed that in the position that it's put in the hydration system is quite low. It's to the point where it's very difficult to reach the straw without pulling it out too far. And this creates more problems when the straw is pulled out too far. One would be it's hard to place it on the magnetic holder after it's pulled out a lot, and the other is that the straw doesn't reach down to the fluid at the bottom of the hydration system.
Was wondering if anyone has firsthand experience using a workaround to the problems I mentioned?
Professional interests in Genomics, Bioinformatics, Hardware/Software interfaces, sports interests are running from 800 to half marathon, sprint tri to half iron, cycling road races
https://brave.com/ - A safer and faster way to browse the web
https://www.strava.com/athletes/3757906
Was wondering if anyone has firsthand experience using a workaround to the problems I mentioned?
Professional interests in Genomics, Bioinformatics, Hardware/Software interfaces, sports interests are running from 800 to half marathon, sprint tri to half iron, cycling road races
https://brave.com/ - A safer and faster way to browse the web
https://www.strava.com/athletes/3757906