I've got a set of a vision trimax cranks that I'm debadging and want to refinish to the bare carbon. I've already sanded the sections with stickers, and removed these entirely, going pretty much down to the carbon. eventually, i'll respray with a few coats of clear.
My question is about those sections of the crank that dont have stickers: should i also snad these down to bare carbon, or it is sufficient to just rough the existing clearcoat to the same finish as the bare carbon? Will there be a perceiveable difference, after refinishing, between the sections I took to bare carbon, and the sections where I had just resanded to the original clearcoat?
My question is about those sections of the crank that dont have stickers: should i also snad these down to bare carbon, or it is sufficient to just rough the existing clearcoat to the same finish as the bare carbon? Will there be a perceiveable difference, after refinishing, between the sections I took to bare carbon, and the sections where I had just resanded to the original clearcoat?