burnthesheep wrote:
Would a Fouriers for a Propel or Trinity work?
Maybe yes, maybe no. It's hard to tell without having one. The original brake is 65mm long with a spring hole above the post, something that is specific to the TTV. The fouriers are 75mm long (as far as I can tell) and I don't know where the spring locator is. The other bit is the "noodle holder" or lack thereof.
jerome2710 wrote:
Quote:
So you had a post made that has a female M6 with a male M8 to screw into the old holes and stand a little bit "proud" from the chainstays?
Correct.
The Helicoil / thread adapters might be an option too. I eventually made the posts myself as I got frustrated receiving non-fitting parts after waiting on shipping as few times. Yours might work, but I thought that a couple of times while ordering as well, haha!
Are you missing the front brake as well? You might try sending Hong Fu a message, as the brakes came with the frame. They may have some laying around still.
There might have been another topic, although I have consulted other forums as well regarding my front brake issues:
Awesome! I've been using your posts to try and figure out what I could possibly use as a replacement. I have an email out to Hongfu, lambda racing, and TRP to see about a front brake. The only one I can find is on ebay for $100 with no pads, no noodle holder, and missing parts. I have to place an order with them anyways as my frame came without the lower brake shield and handlebars. Still, it was very cheap, and all said and done it should come under $500 USD total if I can find a suitable brake setup.