Tools being used : Digital Level 4'; ruler 4'
Step 1: Orient level to 90 degrees vertical
Step 2: Align edge of level with center of bottom bracket
Step 3: Measure horizontal distance from level edge to Bar Bore : this is the measure "X"
Step 4: Orient level to 0 degrees Horizontal
Step 5: Align edge of level with center of bottom bracket
Step 6 Measure vertical distance from level edge to Bar Bore : this is the measure "Y"
I can provide a picture later if this is not enough
Adding some pictures to show the actual measurements and also a close up of the aero-bars. Should I be accounting for the delta between the clamp and the set back of the pads
Step 1: Orient level to 90 degrees vertical
Step 2: Align edge of level with center of bottom bracket
Step 3: Measure horizontal distance from level edge to Bar Bore : this is the measure "X"
Step 4: Orient level to 0 degrees Horizontal
Step 5: Align edge of level with center of bottom bracket
Step 6 Measure vertical distance from level edge to Bar Bore : this is the measure "Y"
I can provide a picture later if this is not enough
Adding some pictures to show the actual measurements and also a close up of the aero-bars. Should I be accounting for the delta between the clamp and the set back of the pads