Tighten the bolt with a torque wrench according to spec (8nm).
All I did was
1) loosen the bolt slightly (2 turns?)
2) took riser post out
3) replace post and tighten up to 8nm
Then I saw this!
Now no part to replace and the clamp is stuck inside too.
Is this common? Something I did?
All I did was
1) loosen the bolt slightly (2 turns?)
2) took riser post out
3) replace post and tighten up to 8nm
Then I saw this!
Now no part to replace and the clamp is stuck inside too.
Is this common? Something I did?