Quick eTap question for anyone out there in the know.
Just setup eTap last night and have everything dialed in perfectly except the FD.
I followed the instructions and have the lines aligned to the chainring, the height appropriately set, the limit screws dialed in. Shifting to the small chainring is butter smooth. However, regardless of position on the cassette, I can't seem to get enough throw to get the chain to catch and fully engage with the large chainring. It tries but can't seem to make it to the top of the rotation (12 o'clock) and this remains caught between the two until I shift back down on the FD.
Normally, I'd recheck the limit screws (done), and then add a little tension to the cable.
However, with no cable, what should I do with FD to tune in the shifting to the big ring? I started over with installation of the FD and ran into the same issue again. I could continue to dial in on the alignment marks and height, but I think I'm pretty well within the error.
Thanks in advance for the assist!
Just setup eTap last night and have everything dialed in perfectly except the FD.
I followed the instructions and have the lines aligned to the chainring, the height appropriately set, the limit screws dialed in. Shifting to the small chainring is butter smooth. However, regardless of position on the cassette, I can't seem to get enough throw to get the chain to catch and fully engage with the large chainring. It tries but can't seem to make it to the top of the rotation (12 o'clock) and this remains caught between the two until I shift back down on the FD.
Normally, I'd recheck the limit screws (done), and then add a little tension to the cable.
However, with no cable, what should I do with FD to tune in the shifting to the big ring? I started over with installation of the FD and ran into the same issue again. I could continue to dial in on the alignment marks and height, but I think I'm pretty well within the error.
Thanks in advance for the assist!